When to use an ACV Rinse

If you decide to follow the Co-washing routine described in the last post, I’d strongly commend you to also incorporate an ACV Rinse washday when you see fit. I use an ACV Rinse when my curls aren’t curling the way it should. This is due to product buildup. Even after using a sulfate-free shampoo buildup can still occur. I prefer not to use a sulfate shampoo because I’m prone to dry scalp and I am also 4C. Apple cider vinegar rinses have saved my hair time and time again.
How to make it
- 1/2 water
- 1/2 apple cider vinegar
- mist bottle spray
Mix both ingredients in the mist bottle spray and shake well. Before starting I’d advise dividing your hair into four to six sections. With each section try to spray the solution directly onto the scalp before straying onto the hair shaft. Massage your scalp well before proceeding to another section. This will not only stimulate your scalp but also help lift any buildup before entering the shower. When all sections are done, cover your hair with a plastic cap. I usually leave it for 30 minutes.
After 30 minutes rinse your hair as you would if you were shampooing. Follow up with a rinse-out conditioner. You’ll notice that your hair will feel like butter. Finally, follow up with a moisturizing deep condition rather than a protein deep conditioner. My favorite is the Shea Moisture Manuka Honey and Mafura Oil Intensive Hydration Treatment Masque.
ACV Rinse Mixed with Aztec Clay Mask

Sometimes I find that my hair needs to get a recharge. Mixing the ACV and the Aztec Clay Mask helps my hair to bounce back. If after the ACV Rinse you’re hair still hasn’t fully bounced back try using this mixture.
Mix all contents in the plastic bowl until it has a thick consistency. Section your hair and apply the mask as you would a deep conditioner. Leave on hair until it hardens. Don’t be alarmed this means it’s working. Rinse the mask in the shower. Then proceed with a moisturizing deep conditioner. Try to do either of these rinses when you need a hair recharge!